QCA9377 error can't detect AP available

[Faiz (faiz akmal adila)]

Help me…
when I want to do pentesting to wifi
using aircrack-ng using my linux parrot
dual boot with Windows 10.
before that I activated monitor mode and succeeded
but I don’t know why after I entered Airodump-ng there wasn’t
WiFi was detected by my linux parrot
but I can use wifi for the internet.
and when I type airodump-ng this is the result
CH 4 ][ Elapsed: 0 s ][ 2020-04-10 03:49

BSSID PWR Beacons #Data, #/s CH MB ENC CIPHER AUTH ESSID

BSSID STATION PWR Rate Lost Frames Notes Probes
.

when i type this rfkill the result
ID TYPE DEVICE SOFT HARD
0 bluetooth hci0 unblocked unblocked
1 wlan phy0 unblocked unblocked
.
please help me

[RightToPrivacy (birdlover)]

Had same wifi chip. They do not open source the firmware and binary avail to public for QCA9377 does not support true monitor mode. Sure, it will say monitor mode is on, but the firmware available does not have the capability.

For more info read this posting on the QCA9377. About 15% down the page they explain monitor mode not being functional in public firmware-

https://developer.qualcomm.com/forum/qdn-forums/hardware/qca9377/34827